Computer Hardware Help Article:

The Right Way To Discharge Capacitor In Switch Mode Power Supplies

There are three ways to discharge the big filter capacitor in a power supply.

1)Discharge it with a screw driver (not recommended).

The reason for not using the screw driver to discharge a capacitor is because

-the printed circuit board or circuitry can be damage due to the spark generated while discharging the high voltage capacitor.I once blowed the power section using this method. However, if you know that the capacitor stored voltage is not too large, you can easily discharge it with a small screw driver.

-if the capacitor holds a heavier charge of electricity. Discharging the capacitor may melt the tip of the screw driver and the copper on the printed circuit board.

-Sometimes a heavier spark may cause small disintegrated solder lead or copper to fly out from the circuit board and may injured your eyes.

2)Place the leads of a socketed 100 watt electric bulb on the leads of the capacitor.

This method had been used by many technicians around the world for the light bulb will act as an indicator to see if the capacitor still holds the charge. If there is a charge the light bulb will light and after discharged the light bulb will goes off.

3)Place the leads of a high wattage resistor on the leads of the capacitor.I use a 2.2k ohm 10 watt resistor to discharge the high voltage capacitor in a switch mode power supplies. It is simple to use and very effective .It takes only couple ofseconds to fully discharge the capacitor.

Conclusion

I strongly suggest for those who use screw driver to discharge a capacitor to swift to the second and third method as these is the safest method to protect the circuit and most importantly is yourself.

Jestine Yong is a electronic repairer and a writer. For more electronic repair information please visit his website atwww.noahtec.com/electronic-repair-articles.htm

The LTO-3 ultrium technology is backward compatible with previous versions so the users of ultrium-3 can access the LTO-1 and LTO-2 archives. Therefore, the investment made by the enterprise is secured for the future. Maxell ultrium-3 cartridge can be used in all the LTO tape drives of third generation.

Installing a new hard drive is a pretty simple task and the actual install only takes a few minutes to complete. The first thing to be done in this process is purchase the new hard drive and make sure that it is compatible with your system this can be done by consulting your motherboard manual and your operating systems guidelines on what hard drives are compatible.

Computers play a huge role in educating today's generation. With the necessity of knowing how word processors, internet connectivity, and other software applications work, it is almost a requirement for each student to have their own computer at home.

Buying a computer is not an easy decision. There are a lot of factors to consider other than just the price. You have to consider your needs, the specifications of the computer, aesthetics, and a whole lot more. And when you do get to finally decide on a computer, other decisions come into play, such as picking the best computer accessories.

However, as technology advances, the prices for these smaller and more powerful electronic devices drop. While the prices have not fallen significantly enough for the devices to be considered disposable, within time they just may.